What is the difference between percussion torx wrench and other torx wrenches?

The difference between percussion torx wrenches and other torx wrenches is that the end of the product is the percussion end. The working end of the twelve-angle hole is suitable for occasions where the working space is narrow and ordinary wrenches cannot be used. Used to unscrew hexagon head bolts or nuts. The corner is small, and it can be used in places where there is only a small swing angle (just turn over 1/2 of the wrench), and because of the large connection surface, it can be used for tightening. There are two types of percussion wrenches: metric and imperial.

The material of the torx wrench: It is made of 45# medium carbon steel or 40Cr alloy steel.

Percussion tools should not be tapped continuously. There should be an appropriate interval for more than ten times. At the same time, the tapping parts of the tools should be cleaned up in time, and then continue to be used after being stained with the debris that has been tapped. Knock and smash tools should be cleaned up in time in the actual operation of debris and oxides corroded on the working surface to prevent the impact of a third party from causing an explosion.

Percussion torx wrench has the characteristics of stable structure, anti-shock, non-folding, constant, non-bending and so on. Use the principle of leverage to turn bolts, screws, nuts and other threaded hand tools that hold the openings of bolts or nuts or sets of holes.

Percussion torx wrenches are suitable for petroleum, chemical, metallurgy, power generation, oil refining, shipbuilding, petrochemical and other industries. Petroleum ships and liquefied petroleum gas vehicles, aircraft, warehouses that operate inflammable and explosive products, electrolysis workshops, communication machine assembly workshops, Places where tools are required to be rust-proof and anti-magnetic. It is a necessary tool for equipment installation and equipment maintenance and repair work.

After knocking the open wrench, it is processed at high temperature. In the high-content sodium hydroxide and sodium nitrite solution, the temperature is above 140 degrees, and a dense oxide film (Fe2O3 and Fe3O4) is formed on the surface of the steel parts. Different steels will have different The chromatic aberration has nothing to do with the roughness; therefore, it should be treated with anti-rust oil after bluing.
www.ratchetspanner.com